What are the basic parameters operating functions of the flame compound machine equipment?

What are the basic parameters operating functions of the flame compound machine equipment?

The large flame laminating machine is used to burn thermoplastic materials (such as sponges made of polyester, polyether, polyethylene other adhesive films, as well as textiles, polyvinyl chloride films, artificial leather, non-woven fabrics other materials) through rapid flame combustion Compound into two-layer three-layer products.

What is flame compound?

Flame recombination can be understood as the rapid burning melting of a sponge by a linear gas burner, the sponge produces a viscous film, when passing through the bonding gap between the pressing rollers, the sponge, the upper fabric the interlining are bonded together.

Basic parameters of flame laminating machine equipment:

Length: 32000mm

Width: 3500mm

Height: 5000mm

Working speed: ≤60m / min

Working width: ≤2000mm

Function operation of flame compound machine equipment

1 Triple sponge release station

2 Welding machine

The part is thermally welded can be connected to materials with a large width of 2000 mm a thickness of 20 mm.

The large flame laminating machine is used to connect the existing materials in the equipment with the materials to be welded.

Before the welding process starts, the end of the material already in the sponge storage is fixed by the clamping station inserted into the welding machine; for the storage of fabrics interlinings, the operator needs to stop the feed roller, the front end of the new material moves to the Welding machine.

After the large flame laminating machine is started, the two materials are pressed together by the welding column through the two-hand control button, then welded together with electric welding wire.

The heating time of the welding wire depends on the material can be adjusted by a potentiometer.

After a certain cooling time (depending on the material can be adjusted by the potentiometer), the large flame composite machine can move the welding column back to the starting position.

Residues generated by welding materials fall on the floor must be disposed of.