How to install pur hot melt adhesive laminating machine as well?

How to install pur hot melt adhesive laminating machine as well?

1. When installing pur hot melt adhesive compound machine, it must be connected to the correct effective grounding wire. Any equipment that uses high-voltage power needs a ground wire. When the ground wire is used, any part of the hot melt adhesive machine with insulation protection may still form a voltage conductor, which may cause electric shock.

2. According to the load required by the pur hot-melt adhesive laminator its peripheral equipment, check whether the power cord insulation protection used meet the requirements. The wire load must be higher than the rated power of the hot melt adhesive machine.

3. Make sure that the pur hot-melt adhesive laminator operates at the specified voltage. If the voltage used is different the specified voltage, it may cause the hot melt machine to burn out.

4. Make sure that the external voltage connected to the pur hot melt adhesive laminator is consistent with the hot melt adhesive laminator itself. For example, if a single-phase 220 volt standard hot melt adhesive machine equipment uses a 380 volt power supply, the spray equipment of the hot melt adhesive machine will be damaged. For example, if a single-phase 220 volt standard pur hot melt adhesive laminator device uses a power supply lower than 220 volts, the design performance of the device cannot be achieved, the pur hot melt adhesive laminator may also be damaged. During wiring, make sure that the power cord is properly connected to the external power circuit breaker.

Advantages of hot melt adhesive compound machine process

1. Transfer mesh glue, strong three-dimensional sense.

2. Strong adhesion, save glue cost.

3. The heat source is oil heat, which heats quickly evenly.

4. Robotic design saves operators.

5. The compound process is controlled by linkage, light weight, softness good feel.